DE/ EN/ ES/ FR/ IT/

Integration

LinMot AOI/AOP Integration: Rockwell

Rockwell Automation Part 1: New Project – Setup of Periodic New Task


AOI/AOP Integration
-Creating a New Project
-Setting Up a Periodic Task
-Setting Up Communication

Reuploaded from December 20, 2018 with louder audio.

Rockwell Automation Part 2: General Housekeeping Instructions


AOI/AOP Integration
-General Housekeeping Instructions
-Switching On/Off
-Homing
-Acknowledging Errors

Reuploaded from December 20, 2018 with louder audio.

Rockwell Automation Part 3: Basic Sequential Moves


AOI/AOP Integration
-Basic Sequential Moves

Reuploaded from December 20, 2018 with louder audio.

Rockwell Automation Part 4: Life-cycle Test or Assembly Process


AOI/AOP Integration
-Life-cycle Test or Assembly Process

Reuploaded from December 20, 2018 with louder audio.

Rockwell Automation Part 5: P10-70 Kinetix® K5700 Servo Drive Integration


LM_MAM Modulo Moves for Rotary Motors


This video covers the modulo move features available for LinMot’s CIP Sync drives, making use of the LM_MAM instruction. This feature can be useful when programming continuous rotation of LinMot rotary motors with absolute moves.

Cip Sync Series

CIP Sync Part 0: LinMot Drive Configuration


This video covers the configuration of LinMot C1250-CM drives for use with CIP Sync.

CIP Sync Part 1: EDS Installation and Module Creation


This video will show how the -CM EDS files are installed and creating the ethernet modules. The AOI sets for the -IP and -CM drives are separate and not compatible.

CIP Sync Part 2: Creating the Virtual Axes


This video will show you the parameters needed for the virtual axes.

CIP Sync Part 3: Periodic Task and Init AOI


This video will cover the Init AOI and its parameters within the periodic task.

CIP Sync Part 4: Event Driven Task and CmdPos AOI


This video covers the event driven task parameters and how to configure the CmdPos AOI. This AOI links the virtual and physical axes.

CIP Sync Part 5: Coordinated Motion Moves


This video shows how the native motion commands control the virtual axis.

CIP Sync Part 6: Advanced Features


This video covers the advanced features in the Init AOI.

CIP Sync Part 7: No Coordinated Motion


This video goes over how to use the LM_ AOIs and control the physical axis using non coordinated motion.

CIP Sync Part 8: Gantry Control


This video show how you can coordinate the X and X’ axes of gantries.

Social Media Europe

Social Media USA

Visit our e-Catalogue Close

Cookies and privacy

This website uses Cookies to provide its customers the best website experience. You will find further information in the policy declaration